7.4.5

Version 7.4.5 [v7.4-stable] 2013-10-22

• mmanon: removed the check for specific “terminator characters” after
  last octet. As it turned out, this didn’t work in practice as there
  was an enormous set of potential terminator chars — so removing
  them was the best thing to do. Note that this may change behaviour of
  existing installations. Yet, we still consider this an important
  bugfix, that should be applied to the stable branch.
  closes: http://bugzilla.adiscon.com/show_bug.cgi?id=477
  Thanks to Muri Cicanor for initiating the discussion
• now requires libestr 0.1.8 as early versions had a nasty bug in
  string comparisons
• omelasticsearch: add failed.httprequests stats counter
• bugfix: invalid property filter was not properly disabled in ruleset
  Note that this bugfix introduces a very slight memory leak, which is
  cosmetic, as it just holds data until termination that is no longer
  needed. It is just the part of the config that was invalid. We will
  “fix” this “issue” in the devel version first, as the fix is a bit
  too intrusive to do without hard need in the stable version.
• bugfix: segfault if re_extract() function was used and no match found
• bugfix: potential misadressing on startup if property-filter was used
  This could happen if the property name was longer than 127 chars, a case
  that would not happen in practice.
• bugfix: omelasticsearch: correct failed.http stats counter
• bugfix: omelasticsearch: did not correctly initialize stats counters
• bugfix: omelasticsearch: failed.es counter was only maintained in bulk mode
  This usually did not lead to any problems, because they are in static
  memory, which is initialized to zero by the OS when the plugin is
  loaded. But it may cause problems especially on systems that do not
  support atomic instructions – in this case the associated mutexes also
  did not get properly initialized.
• bugfix: mmanon did not detect all IP addresses in rewrite mode
  The problem occured if two IPs were close to each other and the first one
  was shrunk.
  closes: http://bugzilla.adiscon.com/show_bug.cgi?id=485
  Thanks to micah-at-riseup.net for reporting this bug
• bugfix: mmanon sometimes used invalid replacement char in simple mode
  depending on configuration sequence, the replacement character was set
  to ‘s’ instead of the correct value. Most importantly, it was set to
  ‘s’ if simple mode was selected and no replacement char set.
  closes: http://bugzilla.adiscon.com/show_bug.cgi?id=484
  Thanks to micah-at-riseup.net for reporting this bug
• bugfix: memory leak in mmnormalize
• bugfix: array-based ==/!= comparisions lead to invalid results
  This was a regression introduced in 7.3.5 bei the PRI optimizer
• bugfix: omprog blocked signals to executed programs
  The made it impossible to send signals to programs executed via
  omprog.
  Thanks to Risto Vaarandi for the analysis and a patch.
• bugfix: doc: imuxsock legacy param $SystemLogSocketParseTrusted was
  misspelled
  Thanks to David Lang for alerting us
• bugfix: imfile “facility” input parameter improperly handled
  caused facility not to be set, and severity to be overwritten with
  the facility value.
  Thanks to forum user dmunny for reporting this bug.
• bugfix: small memory leak in imfile when $ResetConfigVariables was used
  Thanks to Grégory Nuyttens for reporting this bug and providig a fix
• bugfix: segfault on startup if TLS was used but no CA cert set
• bugfix: segfault on startup if TCP TLS was used but no cert or key set
• bugfix: some more build problems with newer json-c versions
  Thanks to Michael Biebl for mentioning the problem.
• bugfix: build system: libgcrypt.h needed even if libgrcypt was disabled
  Thanks to Jonny Törnbom for reporting this problem