Use this documentation with care! It describes the outdated version 7, which was actively developed around 2014 and is considered dead by the rsyslog team.

This documentation reflects the latest update of the v7-stable branch. It describes the 7.6.8 version, which was never released. As such, it contains some content that does not apply to any released version.

To obtain the doc that properly matches your installed v7 version, obtain the doc set from your distro. Each version of rsyslog contained the version that exactly matches it.

As general advise, it is strongly suggested to upgrade to the current version supported by the rsyslog project. The current version can always be found on the right-hand side info box on the rsyslog web site.

Note that there is only limited rsyslog community support available for the outdated v7 version (officially we do not support it at all, but we usually are able to answer simple questions). If you need to stick with v7, it probably is best to ask your distribution for support.


Type: global configuration directive



The $umask directive allows to specify the rsyslogd processes’ umask. If not specified, the system-provided default is used. The value given must always be a 4-digit octal number, with the initial digit being zero.

If $umask is specified multiple times in the configuration file, results may be somewhat unpredictable. It is recommended to specify it only once.


$umask 0000

This sample removes all restrictions.

[rsyslog site]

This documentation is part of the rsyslog project.

Copyright © 2007-2014 by Rainer Gerhards and Adiscon. Released under the GNU GPL version 2 or higher.

Previous topic


Next topic


This Page