Use this documentation with care! It describes the outdated version 7, which was actively developed around 2014 and is considered dead by the rsyslog team.

This documentation reflects the latest update of the v7-stable branch. It describes the 7.6.8 version, which was never released. As such, it contains some content that does not apply to any released version.

To obtain the doc that properly matches your installed v7 version, obtain the doc set from your distro. Each version of rsyslog contained the version that exactly matches it.

As general advise, it is strongly suggested to upgrade to the current version supported by the rsyslog project. The current version can always be found on the right-hand side info box on the rsyslog web site.

Note that there is only limited rsyslog community support available for the outdated v7 version (officially we do not support it at all, but we usually are able to answer simple questions). If you need to stick with v7, it probably is best to ask your distribution for support.

back

$ResetConfigVariables

Type: global configuration directive

Default:

Description:

Resets all configuration variables to their default value. Any settings made will not be applied to configuration lines following the $ResetConfigVariables. This is a good method to make sure no side-effects exists from previous directives. This directive has no parameters.

Sample:

$ResetConfigVariables

[rsyslog.conf overview] [manual index] [rsyslog site]

This documentation is part of the rsyslog project.

Copyright © 2007 by Rainer Gerhards and Adiscon. Released under the GNU GPL version 2 or higher.

Previous topic

$UMASK

Next topic

Legacy Directives affecting Input Modules

This Page