Use this documentation with care! It describes the outdated version 7, which was actively developed around 2014 and is considered dead by the rsyslog team.

This documentation reflects the latest update of the v7-stable branch. It describes the 7.6.8 version, which was never released. As such, it contains some content that does not apply to any released version.

To obtain the doc that properly matches your installed v7 version, obtain the doc set from your distro. Each version of rsyslog contained the version that exactly matches it.

As general advise, it is strongly suggested to upgrade to the current version supported by the rsyslog project. The current version can always be found on the right-hand side info box on the rsyslog web site.

Note that there is only limited rsyslog community support available for the outdated v7 version (officially we do not support it at all, but we usually are able to answer simple questions). If you need to stick with v7, it probably is best to ask your distribution for support.

back

$ActionResumeInterval

Type: global configuration directive

Default: 30

Description:

Sets the ActionResumeInterval for all following actions. The interval provided is always in seconds. Thus, multiply by 60 if you need minutes and 3,600 if you need hours (not recommended).

When an action is suspended (e.g. destination can not be connected), the action is resumed for the configured interval. Thereafter, it is retried. If multiple retires fail, the interval is automatically extended. This is to prevent excessive ressource use for retires. After each 10 retries, the interval is extended by itself. To be precise, the actual interval is (numRetries / 10 + 1) * $ActionResumeInterval. so after the 10th try, it by default is 60 and after the 100th try it is 330.

Sample:

$ActionResumeInterval 30

[rsyslog.conf overview] [manual index] [rsyslog site]

This documentation is part of the rsyslog project.

Copyright © 2007 by Rainer Gerhards and Adiscon. Released under the GNU GPL version 2 or higher.

Previous topic

$ActionExecOnlyWhenPreviousIsSuspended

Next topic

$RepeatedMsgReduction

This Page