Use this documentation with care! It describes
the outdated version 7, which was actively
developed around 2014 and is considered dead by the
rsyslog team.
This documentation reflects the latest update of the
v7-stable branch. It describes the 7.6.8 version, which was never
released. As such, it contains some content that
does not apply to any released version.
To obtain the doc that properly matches your installed
v7 version, obtain the doc set from your distro. Each
version of rsyslog contained the version that exactly
matches it.
As general advise, it is strongly suggested to
upgrade to the current version supported by the rsyslog
project. The current version can always be found on
the right-hand side info box on the rsyslog web site.
Note that there is only limited rsyslog community support
available for the outdated v7 version (officially we do not
support it at all, but we usually are able to answer simple
questions). If you need to stick with v7, it probably is
best to ask your distribution for support.
Ruleset-Specific Legacy Configuration Statements¶
These statements can be used to set ruleset parameters. To set these parameters, first use $Ruleset, then use the other configuration directives. Please keep in mind that each ruleset has a main queue. To specify parameter for these ruleset (main) queues, use the main queue configuration directives.
- $Ruleset name - starts a new ruleset or switches back to one already defined. All following actions belong to that new rule set. the name does not yet exist, it is created. To switch back to rsyslog’s default ruleset, specify “RSYSLOG_DefaultRuleset”) as the name. All following actions belong to that new rule set. It is advised to also read our paper on using multiple rule sets in rsyslog.