Use this documentation with care! It describes the outdated version 7, which was actively developed around 2014 and is considered dead by the rsyslog team.

This documentation reflects the latest update of the v7-stable branch. It describes the 7.6.8 version, which was never released. As such, it contains some content that does not apply to any released version.

To obtain the doc that properly matches your installed v7 version, obtain the doc set from your distro. Each version of rsyslog contained the version that exactly matches it.

As general advise, it is strongly suggested to upgrade to the current version supported by the rsyslog project. The current version can always be found on the right-hand side info box on the rsyslog web site.

Note that there is only limited rsyslog community support available for the outdated v7 version (officially we do not support it at all, but we usually are able to answer simple questions). If you need to stick with v7, it probably is best to ask your distribution for support.

rsyslog.conf configuration directive

$AbortOnUncleanConfig

Type: global configuration directive

Parameter Values: boolean (on/off, yes/no)

Available since: 5.3.1+

Default: off

Description:

This directive permits to prevent rsyslog from running when the configuration file is not clean. “Not Clean” means there are errors or some other annoyances that rsyslgod reports on startup. This is a user-requested feature to have a strict startup mode. Note that with the current code base it is not always possible to differentiate between an real error and a warning-like condition. As such, the startup will also prevented if warnings are present. I consider this a good thing in being “strict”, but I admit there also currently is no other way of doing it.

Caveats:

Note that the consequences of a failed rsyslogd startup can be much more serious than a startup with only partial configuration. For example, log data may be lost or systems that depend on the log server in question will not be able to send logs, what in the ultimate result could result in a system hang on those systems. Also, the local system may hang when the local log socket has become full and is not read. There exist many such scenarios. As such, it is strongly recommended not to turn on this directive.

[rsyslog site]

This documentation is part of the rsyslog project.

Copyright © 2009-2014 by Rainer Gerhards and Adiscon. Released under the GNU GPL version 2 or higher.

Previous topic

Legacy Global Configuration Statements

Next topic

$DebugPrintCFSyslineHandlerList

This Page