Type: global configuration parameter
This parameter models old sysklogd legacy. Note that many people, including the rsyslog authors, consider this to be a misfeature. See Discussion below to learn why.
This parameter specifies whether or not repeated messages should be reduced (this is the “Last line repeated n times” feature). If set to on, repeated messages are reduced. If kept at off, every message is logged. In very early versions of rsyslog, this was controlled by the -e command line option.
What is a repeated message¶
For a message to be classified as repeated, the following properties must be identical:
Note that rate-limiters are usually applied to specific input sources or processes. So first and foremost the input source must be the same to classify a messages as a duplicated.
You may want to check out testing rsyslog ratelimiting for some extra information on the per-process ratelimiting.
Very old versions of rsyslog did not have the ability to include the repeated message itself within the repeat message.
Versions before 7.3.2 applied repeat message reduction to the output side. This had some implications:
they did not account for the actual message origin, so two processes emitting an equally-looking message triggered the repeated message reduction code
repeat message processing could be set on a per-action basis, which has switched to per-input basis for 7.3.2 and above
While turning this feature on can save some space in logs, most log analysis tools need to see the repeated messages, they can’t handle the “last message repeated” format.
This is a feature that worked decades ago when logs were small and reviewed by a human, it fails badly on high volume logs processed by tools.
This turns on repeated message reduction (not recommended):
$RepeatedMsgReduction on # do not log repeated messages
Help with configuring/using